| *
Living Room to Catch a Cheating Spouse.
* Find out What Your Teenager is Up To
When Your Not Around.
* Perfect for a Dorm Room to Catch a
Sneaky Roommate.
* Use it in a Small Business to See
What Employees are Up To.
* Use it To Capture Abusive Nanny's
* Catch a Landlord Sneaking Around
Your Apartment.
* Keep an Eye on Elder Parents to Make
Sure They Are OK.
* Keep an Eye on Your Small Children
Playing in one Room While Doing Work in Another Room.
* Use It In The Basement Or Utility
Room to see What Your Kids Are Up To
The Uses are Endless... Order Yours
Today! |
2.4Ghz. Wireless Video
System
You must charge battery pack before use.
1. Connect the FREE 2.4 GHz
receiver to the 12v power supply, turn the power switch on (LED Indicator
should be on).
2. Connect the 2.4 GHz receiver video
output to the monitor or VCR input using the RCA-RCA cable.
3. You may need to set your VCR to video line input, see note below. Turn on
the 2.4 GHz receiver.
4. Turn on the camera / transmitter by connecting the male plug from the
battery pack to the female plug from the transmitter. This is located inside
the Air Freshener. A 12vdc power supply can also be connected to the female plug
instead of the battery pack.
5. If the signal is not clear, move the 2.4 GHz
receiver. The receiver has an “Arrow” on it. Point the receiver in the
direction of the transmitter. For best performance the receiver should be
facing the Air Freshener.
To charge the battery pack.
1. Plug the battery charger into AC power.
2. Plug the female plug from the battery charger to the male plug from the
12v battery pack.
3. A red led on the charger will be on while charging.
4. Once the led turns a steady green the charging is complete. (Charging
takes approximately 4 hours)
5. Instructions are also included with the charger if you have trouble.
Note.
To set your VCR Video Input.
1. After turning on your VCR, Connect it to the TV using a cable with “F”
connector on both ends, Connect the cable between the VCR “RF OUT” and the
TV “Antenna Input”.
2. Turn on your TV and set it to channel 3.
3. Play any movie on your VCR to check.
4. Using the VCR’s remote, go to “AU”(Auxiliary Input) mode or “Line In”
mode usually found below channel 2. Other VCR’s can get to “AU” mode by
pressing the “Input” button on the remote.
• If you still have trouble, read your VCR’s instructions about video input.
Hidden Camera Wired
1. Connect an RCA cable to the hidden camera’s RCA connector. Connect the
other end of the RCA cable to a TV, VCR, or other recording device.
2. Set your TV or VCR to the input you have connected the RCA cable. If your
TV is connected to the antenna out on your VCR, set your TV to channel 3.
3. Connect the included 12vdc power supply to the 12vdc connector coming
from the hidden camera.
4. Plug the power supply to a wall socket.
5. Video should now appear on your screen. If no image is displayed check to
make sure your TV or VCR is set to the input used.
|
Black
& White
