| *
Living Room to Catch a Cheating Spouse.
* Find out What Your Teenager is Up To
When Your Not Around.
* Perfect for a Dorm Room to Catch a
Sneaky Roommate.
* Use it in a Small Business to See
What Employees are Up To.
* Use it To Capture Abusive Nanny's
* Keep an Eye on Elder Parents to Make
Sure They Are OK.
* Keep an Eye on Your Small Children
Playing in one Room While Doing Work in Another Room.
* Catch a Landlord Sneaking Around
Your Apartment.
The Uses are Endless... Order Yours
Today! |
2.4Ghz. Wireless Video
System
1. Connect the FREE 2.4 GHz receiver to the 12v power supply included. Turn the power
switch on. (LED Indicator should be on).
2. Connect the 2.4 GHz receiver video output to the monitor or VCR input using the
included RCA-RCA cable.
3. You may need to set your VCR to video line input, see note below. Turn on
the 2.4 GHz receiver.
4. Turn on the camera by connecting the clock radio unit to a wall outlet.
The camera is internally connected and needs no other connections.
5. You should see the video from the camera on your
TV. If the signal is not clear, move the 2.4 GHz receiver so that the “Arrow” on the
2.4 GHz receiver, point in the direction of
the camera/transmitter. Please keep in mind the unit will still work
properly without having these units face each other; however, the range may
be decreased.
Note.
To set your VCR Video Input.
1. After turning on your VCR, Connect it to the TV using a cable with “F”
connector on both ends, Connect the cable between the VCR “RF OUT” and the
TV “Antenna Input”.
2. Turn on your TV and set it to channel 3.
3. Play any movie on your VCR to check.
4. Using the VCR’s remote, go to “AU” (Auxiliary Input) mode or “Line In”
mode usually found below channel 2. Other VCR’s can get to “AU” mode by
pressing the “Input” button on the remote.
• If you still have trouble, read your VCR’s instructions about video input.
> Important Note: The piece of equipment operates in amateur radio service
frequencies. We urge all users to observe all laws and regulations governing
its use.
Hidden Camera Wired
1. Connect an RCA cable to the hidden camera’s RCA connector. Connect the
other end of the RCA cable to a TV, VCR, or other recording device.
2. Set your TV or VCR to the input you have connected the RCA cable. If your
TV is connected to the antenna out on your VCR, set your TV to channel 3.
3. Connect the included 12vdc power supply to the 12vdc connector coming
from the hidden camera.
4. Plug the power supply to a wall socket.
5. Video should now appear on your screen. If no image is displayed check to
make sure your TV or VCR is set to the input used. |
